Bolzzen Electric Scooter Electric Bikes
BOLZZEN HELP CENTER
< All Topics
Print

Getting Started

Now it’s time to get going with your Bolzzen Commando and setup for your first exhilarating ride with one of Australia’s favourite Electric Scooters.

Folding and Unfolding

After you’ve unboxed all your goodies, now comes the time to unfold your Bolzzen Commando and get it ready to rock! When it comes to folding and unfolding, it’s never been easier!

To unfold, place your Commando on the ground, place some downward force on the deck and raise the stem upwards. You’ll reach a point where the locking bar slips into place, now pull down the secondary security clip to lock the handle in place.

To fold, again place some downwards pressure on the deck, lift the secondary security clip, and push the stem forward a little and pull the hook at the bottom of the stem, this will release the locking bar allowing you to fold your Commando.

If your stem feels a little wobbly, or insecure, please make sure to double-check that the locking bar is seated fully in its recess. Doing so will provide you with a very solid Commando.

Charging the Battery

Whilst we ship our Electric Scooters with a little bit of power, it’s important to give your Commando a full charge before setting out for the first time.

Remove the plastic and tie-wires from your charger and plug it into the wall and turn it on. Then, carefully plug it into the deck mounted port. Ensure you’ve got a tight, clean connection.

Whilst the charger is connected, the status light will be Red whilst charging and Green when fully charged; a full charge should take anywhere from 9-12 hours.

For best performance, make sure you’re charging outside of temperature extremes. Anywhere between 5°C and 40°C should be fine. Outside of these, internal protections in the battery will trigger and charging will stop.

Table of Contents